Raspberry B+

The Raspberry 1 B+ board is a small PC to develop your own IOT projects. The board is features with a slim size but high performance. 

In combination with the Razberry module by Z-Wave.Me you can easily build a powerful Smart Gateway. Use the Raspberry 1 B+ as the base and plug on the Razberry module. Thanks to the included license for the Smart Home Software Z-Way you can build an own Smart Home Gateway in just a few steps.  

Features:

• Chip Broadcom BCM2835 SoC
• Core architecture ARM11
• CPU 700 MHz Low Power ARM1176JZFS Applications Processor
• GPU Dual Core VideoCore IV® Multimedia Co-Processor
• Provides Open GL ES 2.0, hardware-accelerated OpenVG, and 1080p30 H.264 high-profile decode
• Capable of 1Gpixel/s, 1.5Gtexel/s or 24GFLOPs with texture filtering
• and DMA infrastructure
• Memory 512MB SDRAM
• Operating System Boots from Micro SD card, running a version of the Linux operating
• system
• Dimensions 85 x 56 x 17mm
• Power Micro USB socket 5V, 2A (power adapter not included)
• Ethernet 10/100 BaseT Ethernet socket
• Video Output HDMI (rev 1.3 & 1.4)
• Composite RCA (PAL and NTSC)
• Audio Output 3.5mm jack, HDMI
• USB 4 x USB 2.0 Connector
• GPIO Connector 40-pin 2.54 mm (100 mil) expansion header: 2x20 strip Providing 27 GPIO pins as well as +3.3 V, +5 V and GND supply lines
• Camera Connector 15-pin MIPI Camera Serial Interface (CSI-2)
• JTAG Not populated
• Display Connector Display Serial Interface (DSI) 15 way flat flex cable connector with two data lanes and a clock lane
• Memory Card Slot Micro SDIO